Home maintainance

Started by trout, March 14, 2013, 09:44:33 AM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

robbiegal

well they are just sooo cute and gorgus

trout

Bugger


When you see a puddle in the middle of the paddock between the pump and the house tank you just know there is a heap of digging and swearing in front of you :dash1:

You Mob in the "Big Smoke" don't have these problems but in the bush this happens quite a lot :cray:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

Unicorn


trout

Quote from: 'Unicorn' pid='23752' dateline='1375504063'Poly pipe trout?

yeh and old crappy stuff.
I have drained the house tank and put in a shut off valve to stop the water flowing back to this leak ( I can't believe there wasn't a valve there).
Once the tank is full again I will shut the pump down and close the valve.
It will take a day or so to drain the leaky area so that I can dig down the 4-5 feet to get to the pipe and repair it.
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

Robster

Best of luck with the repair.!:shok:
\"Everything in moderation, including moderation\".

trout

Quote from: 'Robster' pid='23754' dateline='1375506882'Best of luck with the repair.!:shok:

Thanks Mate :angel:
I have to go away for a week so it should be dry enough to dig by then :yahoo:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

JeffH

Gee, I had an empty tank the other day...and a big swampy patch down the back!
Digging, draining the hole (swearing helps) and a cut and replace exercise for a cracked PVC fitting.

I can relate to that.
Thinking is dangerous, it makes you think. That\'s why many people avoid it.

trout

Quote from: 'JeffH' pid='23760' dateline='1375514032'Gee, I had an empty tank the other day...and a big swampy patch down the back!
Digging, draining the hole (swearing helps) and a cut and replace exercise for a cracked PVC fitting.

I can relate to that.

The hardest part is finding the fittings needed to do the repair, There is NO way to tell what you need until the hole is dug and the problem inspected.
That normally (For me) includes a 70k trip into town to get the bloody fittings :dash1:
I am SOOOOOO not looking forward to this when I gat back home :cray:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

Unicorn

Hopefully it'll be less than 4-5 inches long which a joiner should repair (unless it is a joiner that's popped)...... but I'd hate burying $60 too ...... if it's longer than that you'll bury two!

(I might have to adjust that $ if it's less than 2" poly)

Does the ground move much over your way? Regardless I dare say you'll have it sorted in no time when you compare it to the stuff you work on during the day.

I almost wanted to go down the Beverly Hillbillies theme ....... up through the ground came a bubblin' ........

purplepennyhunter

I hope you didn't waste too much water before you found it.
Co-Founder Australian Coin Forum

Unicorn

How'd ya get on with the hole Trout?  :heat:

trout

Quote from: 'Unicorn' pid='24480' dateline='1376152290'How'd ya get on with the hole Trout?  :heat:

I got home yesterday afternoon after doing night shift, I have just woken up.
That busted pipe will be my nemesis today :ok:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

trout

Hole is dug and pipe fixed WOOO HOOOO :yahoo::yahoo::yahoo::wavemulticolor:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

Australian coin


Unicorn

That was quick Trout, good on ya!

Split pipe or a popped connector, or neither? (Just curious .... all mine is on top of the ground .... but I only use it to irrigate or for stock water ..... apart from the tanks to the house which is only about 5m long and down a foot).