To Slab or not to Slab

Started by stevo1962, July 09, 2015, 03:35:59 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

stevo1962

Like many of us I have a couple of these and I've been tossing up whether of not
to send them to PCGS for slabbing.The questions regarding this decision being

1  Will they degrade if left in the packaging
2  Will they hold their value if removed from the packaging
3  Is it worth slabbing a coin when they will all probably
    grade within 2 or 3 points  from each other

  What is everyone doing with theirs?

It\'s not about who you know it\'s about what you know

Fulvio

The back of the coin is sitting against the card. Should be safe, but I would put the whole thing in Mylar I think.

You can only ever remove it from its packaging once. So as long as the packaging isn't doing any damage (it isn't), you can defer the decision.
http://fulvio55.altervista.org/ - Decimal Mintages and Polymer Notes PDFs
Doge: DG8r9JJnWCHVvd1iG4BJeJMj5g1reYTnSc - BTC: 1FFnNxMDNCnQEjHrh9EhnHZoDMjkbf1seW

robbiegal

There is probably 50  if them at pcgs right now

trout

Everyone knows my feelings regarding the crappy mint packaging :ok:
My 2 are at California as I speak :)

Both of mine were in surprisingly good nick and I expect an MS66-67 grade for them (pretty much the average grade for an ali bronze 25mm coin).
I suspect that if left in the mint packaging they can only get worse as time goes by :ok:
Just my opinion but I would rather heat seal these in a saflips or get them graded in the new "air tight" slabs rather than put my trust in the RAM packaging to preserve the integrity of this particular coin.
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

purplepennyhunter

Have a close look at them. I have seen one with glue from the card on the coin.
Co-Founder Australian Coin Forum

trout

Quote from: 'purplepennyhunter' pid='75530' dateline='1436695460'Have a close look at them. I have seen one with glue from the card on the coin.

YUK, have you sent yours on a "holiday" PP ?
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

oh my florin

I'd give it a shot if I had enough coins and money to send over. MS67 would be pretty good considering the nature of the PNC packaging however knowing you stevo I wouldn't be that surprised with a 68.

trout

The dollar coin is a "No Brainer" to get slabbed.
The ones I got were of good quality , they are scarce and would be far better off IMHO in one of then new airtight slabs from PCGS than left in a musty drawer in the crappy packaging provided with them .
The 20 cent coins however with their dull as dishwater designs and second rate minting quality have been chucked in the box with the crappy ABC coins and wont be spending anytime on an aircraft as far as I am concerned :angel:
Aim well to enjoy life. You only get One shot at it.
Illegitimi non carborundum

runway

I'm happy to keep my $1 Poppy in it's official card knowing the obverse is not seated on the cardboard
Buy what gives you enjoyment

purplepennyhunter

Quote from: 'trout' pid='75531' dateline='1436695867'
Quote from: 'purplepennyhunter' pid='75530' dateline='1436695460'Have a close look at them. I have seen one with glue from the card on the coin.

YUK, have you sent yours on a "holiday" PP ?

No. My entire dollar collection sits unslabbed.
Co-Founder Australian Coin Forum